After a minimum of 8 hours, apply a clear, protective finish such as Minwax ® Fast-Drying Polyurethane, Minwax ® Helmsman ® Spar Urethane or after 24 hours, apply clear Minwax ® Polycrylic ® Protective Finish.Dry times may be extended due to high humidity, low temperatures or inadequate ventilation.To Darken color, apply a second coat after 4-6 hours, repeating application directions of first coat.Wipe in the direction of the grain, while blending light and dark areas to obtain uniform color. Remove excess stain with a clean cloth.Let the stain penetrate 5 -15 minutes to ensure you achieve the desired color.Apply Wood Finish™ in the direction of the grain with a brush or clean cloth.To lighten any color, add Minwax ® Wood Finish™ 209 Natural to the mixture.Test stain on a hidden area to verify desired color.Stir stain thoroughly before and occasionally during use.Apply stain within two hours of pre-treatment. This will help the wood evenly absorb stain color. Pre-treat soft or porous woods such as pine, maple, alder and birch with Minwax ® Pre-Stain Wood Conditioner.Sand the wood in the direction of the grain, first using medium grade sandpaper (#120) and working your way to fine-grade (#220).While our samples are tested for accuracy, it is always best to first test Minwax ® Wood Finish™ on a small, inconspicuous spot on the project. Because every piece of wood is unique, final stain color may vary. Wood can vary in color and pore structure even within the same species. Why don't some woods match the colors on the Minwax ® product brochures and samples? Then mix enough stain to complete the entire project to avoid color-matching later. Experiment with different proportions until the desired color is achieved. There may be times when a desired stain color can only be achieved by mixing two colors. Can Minwax ® Wood Finish™ colors be mixed to create additional colors? Does Minwax ® Wood Finish™ need to be top-coated?įor added beauty and protection, we recommend topcoating all projects with a protective clear finish such as Minwax ® Fast-Drying Polyurethane or Minwax ® Polycrylic ® Protective Finish. Since Minwax ® Wood Finish™ does not raise the grain, no sanding is necessary before top-coating. Sanding will result in the removal of some of the dyes and pigments in the stained wood. Is it necessary to sand after the Minwax ® Wood Finish™ has dried? Any pigments allowed to remain on top of the wood will impair topcoat adhesion - causing the finish to peel. The colorants in Minwax ® Wood Finish™ are designed to be deposited in the wood pores, not on the surface of the wood. Why is it important to wipe off the excess stain? For a light tint, wipe the excess stain off after a few minutes for deeper, richer color, wait as long as 15 minutes. The longer the stain is left on the wood, the deeper it will penetrate. How long should Minwax ® Wood Finish™ be left on the wood?Īnywhere from a few seconds to 15 minutes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |